Blasters, Sweepers & BlasterVacs

Blasters and BlasterVacs are shown and described below. They are used for road, bridge, and runway surface cleaning projects and for high-speed scarification. As opposed to regular scarification, high-speed scarification removes less than one-quarter inch of concrete.

Blaster

A photo of Rampart Hydro hydro jets exiting the Blaster cleaning unit

Rampart’s Blaster is a surface cleaning unit that removes rubber from airfield runways and paint from roadways, quickly and completely.  Rubber can be removed at rates exceeding  30,000 square feet per hour, and paint is stripped-away at about 5,000 square feet per hour.  Like the BlasterVac, it is a self-contained, and in case of emergency, can cease operation in thirty (30) seconds, and exit roads or runways at highway speeds.

The rotating 28 jet spray bar has a removal width of twelve (12) to  twenty-four (24) inches at operates at 36,ooo psi.

A Blaster truck holds enough water to clean over 100,000 square feet at a time. The unit is environmentally safe.  It requires only potable water; no chemicals are needed or used.  The water, which is heated to about 140° when forced through the tiny spray nozzles, is sufficient to do the job.

The rubber and paint debris is vacuumed from the runway surface and properly disposed in a landfill–either with a Sweeper/Vacuum Truck or a combo Blaster Vac truck.

Sweepers

Rampart uses air regeneration sweeper trucks(broom assisted) to collect wastewater, rubber and dirt debris created by the high-pressure surface cleaning.  With its seven foot vacuum width, it follows the Blaster truck to insure a clean surface.  The rubber or paint debris is properly disposed of according to all federal, state, and local environmental regulations.

BlasterVac Trucks

A photo of Rampart Hydro hydro jets exiting the Blaster cleaning unit

Rampart’s newest airfield rubber-removal equipment combines the functionality of both a Blaster truck and a vacuum truck into one vehicle.

The BlasterVac removes rubber from the runway while continuously vacuuming the debris and wastewater . Like a regular Blaster truck, the BlasterVac is self-contained, . and have a removal and vacuum width of 24 inches, allowing it to perform it’s job quickly and completely.

.